We install and repair wet (water-based) underfloor heating systems. Most of our UFH work is diagnosing and fixing systems that aren't working properly — either the whole system or individual zones. If yours has never quite worked right, that's exactly the kind of problem we're good at.
Many UFH systems were installed without proper commissioning, without instructions, or with controls that aren't set up correctly. The system often isn't broken — it just needs someone who understands how it should work.
Some zones warm, others cold. Usually a balancing or setup problem rather than a fundamental fault.
You don't know how to operate or adjust the system because no one showed you. We'll set it up properly and explain how it works.
Water reaching the UFH loops is too hot or too cold. Gets the temperature wrong across the whole system.
Circulation pumps, actuators, mixing valves, control thermostats, diverter valves, leaky manifold connections. We diagnose which component has failed before replacing anything.
A UFH system without a bypass can damage the boiler over time. This isn't always obvious until something fails. We check for this as part of any UFH diagnostic.
Controls that don't do what they should, or a system that was never set up with proper zone control in the first place.
Sometimes the problem is one zone, not the whole system. We identify whether the fault is system-wide or localised before recommending any work. We figure out what's actually wrong rather than swapping parts until something works.
We'll diagnose the problem and quote for the fix. Call or WhatsApp and tell us what's happening.
